Aviom MH10f Guía de usuario Pagina 117
- Pagina / 144
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
105
F
IRMWARE UPDATE
device.
To enable firmware updates on the module, press FUNCTION, followed
by the CHANNEL 15 ACTIVE button. The Enter/Cancel LED and the channel
level LEDs will flash to indicate that this function will interrupt normal
network operation. Press E
NTER to enable the module to receive new
firmware from the PC host. Send the firmware update following the
instructions that came with the Pro64 Update Tool. During the update
the sixteen red, yellow and green channel meter LEDs will flash in
sequence.
When the firmware update has been sent successfully, the module will
reset and normal front panel operation will be restored. If for some
reason the firmware update fails, refer to the error recovery information
below for instructions on how to recover and complete the update.
When a module is being updated locally, the dot in the VDC Slot display
will be on, indicating that a local firmware update is in progress.
When a module is waiting for a firmware update to begin, you can exit
the firmware update state by pressing the C
ANCEL button. If the firmware
update has not yet started, the module will attempt to reset, returning it
to normal operation.
N
OTE: Do not press the CANCEL button while a firmware update is in
progress.
Error Recovery
In case of a partial firmware download or interruption to the firmware
transfer (as would happen because of a power failure, computer crash,
or by pressing the Cancel button in the middle of a firmware update), the
module can still be updated but will need to be powered up directly into
the firmware load mode. To do this, hold the VDC Slot decrement (down
arrow) button while powering up the unit. Then send the firmware from
the computer as described previously.
Firmware Update - via A-Net
To enable a Pro64 module to receive new firmware via A-Net on an active
network, the PC must be connected to the RS-232 port on the Control
Master. The network must be in Managed Mode to update firmware via
A-Net. All network audio will be muted, and front-panel functions will
be disabled on the module being updated.
To enable firmware updates, a module must be selected from within the
Pro64 Update Tool application, at which point it will be set up to receive
new firmware. Send the firmware update following the instructions that
- User Guide 1
- WARNING! 3
- Important Safety Instructions 4
- Warranty Information 5
- Aviom, Inc. Limited Warranty 6
- ABLE OF CONTENTS 7
- Features 13
- The EtherCon Connector 14
- AC Power 15
- AC Line Conditioning 15
- Rack Mounting 15
- Ventilation 16
- Cleaning 16
- About A-Net 17
- Clocking 18
- Control Data 18
- A-Net Ports 18
- BOUT A-NET 19
- Button Presses 20
- Changing Values 20
- Selecting Values 21
- DIP Switches 21
- Basic Actions 22
- NTER button 22
- A-Net Slot 23
- Slots and Sample Rate 24
- A-Net Slot Display 25
- ANCEL button 26
- A-Net Slot Example 27
- 64 USER INTERFACE 28
- Network Modes 29
- Pro64 Network Concepts 31
- Control Master 31
- Control Master Functions 32
- Changing Settings 33
- MIDI Out 34
- GPIO Out 34
- Network Sample Rate 35
- Mute Mute 36
- Managed Mode 37
- Password Protection 38
- ONTROL MASTER 39
- 6416m Front Panel Components 40
- Input Module 43
- Mic Input Module 44
- A-NET SLOT 46
- Network Mode 47
- A-Net Transmit 47
- Clock Master 48
- Sample Rate 48
- NTER button. To exit without 49
- A-Net Slot Configuration 51
- Enter/Cancel Buttons 53
- A-Net LED 53
- Managed Button 54
- Edit Lock Button 54
- Query Functions (Get Info) 55
- Control Group 56
- Channel Activation Button 57
- Level Meter LEDs 58
- Stereo Link Button 58
- INK button 59
- Mute Button 59
- UTE button once to activate 59
- Edit Button 60
- Phase Button 60
- Gain (dB) 61
- +48V Phantom Power Button 62
- FRONT PANEL 64
- Mic Preamp Presets 65
- Recall a Preset 66
- Preset Rules 66
- Backup DC Power 67
- Balanced Mic/Line Inputs 68
- DB25 Audio Thru/Alternate In 69
- DATA CABLES 70
- Configuring a VDC 71
- 72
- GPIO INPUT 72
- MIDI In, MIDI Out 73
- RS-232 Port 73
- RS-232 Baud Rates 74
- Control Master DIP Switch 75
- HEADPHONES 76
- CONTROLLER 77
- RCI Rear Panel Components 78
- Headphone Input Jack 79
- Monitor Volume Control 79
- Network Mode Selection 79
- Group 4Group 3 81
- BACKUP POWER 83
- AC POWER 83
- FUSE: VAC-FAL 83
- +dBu LINELEVEL OUTPUT BAL 84
- MCS Components 85
- Channel Level Meters 87
- Numeric Keypad 87
- NTER button. The 87
- Inc/Dec Selection Buttons 87
- No Control Indicator 89
- Save and Recall Buttons 89
- Cancel and Enter Buttons 90
- Gain Display 90
- Gain Control 91
- Low Cut Button 92
- Pad Button 92
- High Resolution Meter 93
- Peak Hold Button 94
- EAK HOLD button 94
- Controller Connector 94
- Choosing a Network Mode 95
- Connecting Pro64 Modules 95
- Basic Routing 96
- Auto Mode Connections 96
- B A 97
- Manual Mode Connections 99
- A PRO64 NETWORK 100
- Digital Copies in Manual Mode 103
- VDC Configuration 106
- VDC In Use LED 107
- NTER to deactivate the 108
- NTER button to activate it 109
- ANCEL button. Pressing 109
- Advanced Functions 109
- Function Button 109
- UNCTION button; its button 109
- Clear A-Net Resources 110
- Mute/Unmute all Channels 110
- Password Lock 110
- Password Unlock 111
- Set a New Password 111
- Sample Alignment 112
- FUNCTIONS 113
- Restore Factory Defaults 114
- Firmware Update 116
- UNCTION, followed 117
- UPDATE 118
- 6416m Block Diagram 119
- 6416m Specifications 120
- Specifications 121
- Dimensions - 6416m 122
- RCI Specifications 124
- Dimensions - RCI 125
- MCS Specifications 127
- Dimensions - MCS 128
- Mounting the MCS 130
- GPIO Specifications 131
- GPIO Plugs 132
- MIDI/GPIO Cable Lengths 132
- Wiring an Analog DB25 Cable 133
- Using DB25 Jacks 134
- RS-232 Connections 135
- Wiring a Crossover Cable 136
Relacionado con productos y manuales para Instrumentos musicales Aviom MH10f
Instrumentos musicales Aviom MH10f Guía de usuario
(41 paginas)
(41 paginas)
Instrumentos musicales Aviom MH10f Guía de usuario
(41 paginas)
(41 paginas)
Instrumentos musicales Aviom MH10f Manual de usuario
(16 paginas)
(16 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.117 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales